Good info! Would like to do this to my '77 Liquifire.

Thanks for the reply Don! Sled is in southern Minnesota but we dont have snow here either. LOL

So who wants it? Line starts here. LOL

Thinking of selling my '77 Liquifire. What is it worth? Is 7-800 out of line? New crank seals New needle & seats New fuel lines New thermostat New wear rods New belt Carb boots New Joe Rainville repro windshield New ignition coils New rollers in primary clutch Rebuilt fuel pump Skis, springs and...

Thanks for the replies guys! Can't pay too much attention to the belt deflection in the picture I posted. That was last winter and the engine hadn't been run yet. The belt was just put on. I'll take a look at the deflection now that it's been ridden. Engine was put back in the same position. Don't h...

New crank seals only. Not rebuilt. New button and rollers in the primary clutch Cleaned the secondary, original spring. New cam sliders New ignition coils Carbs cleaned and new needles and seats Rebuilt fuel pump All new fuel lines and filter NOS thermostat New belt Jetting is all factory specs http...

Finally got my '77 Liquifire snow ready and the weather cooperated with about 8" of fresh snow. Got the NOS t-stat installed that I got from Don Amber. Threw in some new needle and seats in the carbs. Got to put about 20 miles on it this weekend, keeping close to home in case I had to walk. LOL...

Mine is still in the box...
No snow here, temps forcasted to be 40+ all next week. Probably wont be riding this year.

Yep just get a new one. I when the used route and didn't work.

Thank you!

Any updates?

Thanks!
Reed

I say do the short Dator cut windshields and call 'er good.
Thanks for taking the time to reproduce these.
I'd be in for a shorty for my '77 Liquifire.

Yep if you can get it for the rear suspension. I'd like to upgrade my '77 suspension to a '78 someday.

Cool story!

Looking good!

Did you check into the chrome Rupp shocks for the rear?

My Liquifire shock measured less than 7" compressed and 8 3/8" extended. Eyelets are 7/16"