I only have the style from my 77 300, not sure if they are different.
I can send pic if you wan just give me your email

Awesome I think I even have a couple of those!
Thanks

My rear light was intermittent so I decided to take it apart...of course bulb broke.. It looked rough I'm assuming that's the issue or the ground on it
Sled is a 77 300, anyone know what bulb is the right one?

Still have?

Have big pile of parts
Ccw 400
Ccw 440
Walbro wd carb complete pretty clean with two other parts walbro carbs
Tillotson Carb
I have three tracks from 300 and jdx
Lots of bogies , guages, plastic parts
Just ask I may have it!

Some good news... I fiddled around trying to get spark on the 400 with no luck...I then decided to swap back in the original 295 motor and tryout the tillotson hd carb....fired right up and was running ok then started getting a little funky. I got a full rebuild kit for that carb locally and rebuilt...

Ok perfect thanks a lot for all the help ! I'm starting to think I can just put on the tillotson the kohler which I know had spark and go from there From what I have discovered it appears that the points aren't opening at all... The magneto mut have thrown something off when it was loose. The coils ...

So I have a kohler 295, ccw 400, ccw 440
Walbro wda31, tillotson, and bendix carb

What carbs can interchange with which motor?...maybe I can use the tillotson hd carb with kohler?
Or bendix?

From my reading all these carbs aren't all that good..opinions..??

Basically all I need is the one seal inside

Yeah I'm well aware of the crank seals!! They are on order...

Just unusual how I lost all spark for some reason....gonna spend some more time diagnosing tonight

Thanks for reply! I just found it wierd that it was working fine And dandy for a short while and then just cut out and now no spark. Also I have unugged the harness to confirm its not ignition switch or kill switch One think I've wondered is which coil does which cylinder? I noticed the wires on coi...

I've been battling this 77 John Deere 300 (kohler) for years trying to get it running again Finally gave up on it I suspect the walbro carb is my issue and was tired of fiddling with it. I recently acquired a ccw 400 which appeared complete and in good condition. I did some work and dropped it in, i...

I always put air breather, snorkel whatever you want to call it when I attempt to diagnose it. I have fiddled with the carb settings as well as the fuel metering arm in the carb. I tried to adjust it to what the repair manual says....didn't seem to make much of a difference It starts, usually begins...

Finally got a little work started... Changed te clutch side crank seal, it appears the "mechanic" installed the plate which seal goes into upside down. If you guys are really familiar with these kohlers... the plate has basically a 3" (roughly) circle about 1/4" deep tht basicall...

Ok thanks guys! Yeah obviously the check valve isn't working all that great! I hate havin to pull a million times, once fuel is there it fires up instantly. I do recall checkin the metering arm thing... Ill have another look when I get greasy but I do recall it all functioned good until I got a snow...