hi Brad,
2 sets plus shipping.....408.00.
thanks,
Larry

price for Liquidator pistons, rings/set, shipping. pistons, rings, clips, pins, bearings...set of 2...198.00 rings...............set per piston.................... 22.00 flat rate shipping inc. delivery confirm.............12.00 please get to me with your final orders. checks......Larry Houge box 97...

the liquidator pistons are here and the bearings should be here within a couple of days........ price will be app. 198.00 per set of pistons including rings, pin, clips, and bearings. i will have know the price of the rings when they arrive with the bearings. i will post the firm prices when the bea...

sorry......been a little preoccupied and haven't updated anyone....my bad.
i am waiting on the bearings. i'll check in with Wis tomorrow.

certifiable

thanks for the tally Chuck. might be good if any of you here know of guys that want to make a last second jump...they can get a run at it. i can give a day to that. i know even though it's at the wire, guys want to review.......i do the same thing myself when i buy stuff. any of the guys making the ...

thanks Todd,

ok guys, ............any last minute concerns, questions, problems before the Liquidator piston projects gets lit up?

Certifiable

19 mm problem taken care of.......thanks guys. the order for the run will now be sent in first of the week. std's and .020 over will be ordered with the 18 mm pins and bearings. will also order std and .020 over rings....and yes, the same type/style of rings will be used as in first run so they will...

no argument from me re keeping it simple. i guess i think i have to try to throw the options out there as they come up and then depending on response pare it back to something workable....and not cost prohibitive. having said that, does anyone have one or three first run pistons with 19 mm pin and b...

thanks for the note, sledder670 wasn't up to speed on this one since it was not available when other pistons were produced. i contacted Wis and am waiting for a call back. if the Armorglide (tm) is available for these pistons......HOW MANY GUYS ARE INTERESTED IN IT............??? i had planned to pl...

hey guys the 18's will fit the bill for the liquidator piston project. am going to PLACE THE ORDER TOWARD THE END OF NEXT WEEK. sounds like most guys want standards but you will have to let me know of ANY INTEREST IN OVERSIZE?.... 0.20. also......any interest in 19's (pins) at all???..........withou...

thanks guys, i'll contact them tomorrow with your information. i appreciate the help. in about a week i will place the order....i'm guessing there will still be guys wanting a few oversize pistons....and a small group with 19 mm pins. i'll make adjustments to get the right mix and extra rings for bo...

hello guys, i need some help. i have been running this 18 mm pin and bearing through my mind and have this very slight thought..."what if we're wrong about the measurement of the rod end for the od of the wp bearing". close doesn't count here, this is new ground, and any error blows this p...

As Kenny said, the L piston crown is higher and piston is longer than the S piston. I did not have the right stuff to gauge the rod width and do not have an L crank here to check if there is a difference.
good question.
certifiable

guys, please check RACE SLEDS for update re liquidator pistons.
thanks
certifiable

I have been off site for awhile but I got the word :bonk: this spring that there are guys that want std Liquidator pistons. I talked with Wiseco about the pistons and also the WRIST PIN BEARING since I do not have enough bearings left for another run. I asked Wiseco if they had any 19 mm bearings an...