Thanks for the info! I'll try looking them up.

Tom

Can anyone tell me where I can get a new rear shock and the bar it attatches to that runs between the slide rails ( or measurements of it O.D./ length) for my 80 Liquifire?

OK guys this is the same sled that was running to lean and now is wanting to flood out when driving at a slow speed about 20mph for about 15 to 20 minutes and she loads up so bad I gotta hold WOT forever to getter cleaned out. Just ran across this on sunday while the kid's were puttsin around the ya...

Rich, I usually make a habit of hitting Big Buck while I'm up visiting. Still haven't decided on my favorite flavor, so I usually go with their sampler (or two). They do an excellent steak also. My brother's on the West side of Otsego Lake, do they still have a vintage sled show up there? He hasn't ...

Thanks for all your replies! When I cross referenced the QN-2/ N-2 on the NGK website it gave me B8's seeing as you guy's were stating the smaller the # the hotter the plug, I went with 9's to be safe. I ran it yesterday for about 45 minutes after rejetting the carbs to the 81 spec's Rich had given ...

What are the proper plugs for my 80LF? Got this sled from my brother in-law and he has 3 different sets of sparkplugs. Anybody no what size I should be using?

Thanks, Tom

"159" is correct. I was trying to get all the jet's before dissassembly of the carbs, but took them apart this weekend and did find the 159# on the needle jet. Thanks for your reply it is greatly appreciated! I'm hoping this is going to help with this sled running after she gets hot. I'm r...

Awhile back Rich had given some carb. set-up's for 80-81 LF's. Seeing as I had a 3.5 cutout I'm going with the 81 set-up he had given with a P-4 needle jet, but the guy at sports mart asked what series it is. Does anyone know if they made different series in the same model year or should the part's ...

Thanks for your reply, but have already replaced/rebuilt fuel pump,carbs,pulse line & fuel lines. I do have an air screw that looks like it has been over tightenend and might be bent. Do these air screws tighten into replacable seats? Any ideas on where I could find some new ones? Thanks again!

Hello, I'm new to this site and have read alot of the postings and have some ideas but could use some advice. Was given a 1980 liquifire and went through (what I thought was) everything. Pistons,rings,bearings,seals,carbs,fuelpump,fuel lines& filter, oil lines & filter,pulse line. Sled did n...