1983 snowfire missing at 3/4 throttle
-
- Posts: 6
- Joined: Mon Nov 10, 2014 2:18 am
- Real Name: victor lee wooldridge
- Location: underwood,iowa
1983 snowfire missing at 3/4 throttle
hi I have a 83 snowfire I think at the rev limiter is dealing me fits. where is it mounted and can I just unplug it like a liquifire. I have a 82 at runs perfect. how do you check it ? will not idle and have too hold throttle half open too start no mather what. but once she takes off she'll lift the skis then starts stuttering . I had the carb apart and clean it 3 times it's not it , will rule at out by putting the 82's on it and try it. I will also check for blown head gasket but I don't think at"s it because it pulls hard like the 82. not an air leak because I pressured check it after I put all new gaskets and seals in it. it's has to be the rev limiter at's dealing me fits. thanks for your time. lee
- jdrob
- Posts: 1212
- Joined: Thu Feb 25, 2010 1:23 pm
- Real Name: Rob
- Location: Pennsylvania/OHIO border
Re: 1983 snowfire missing at 3/4 throttle
You can unplug the rev limiter. I seen them mounted everywhere. hood,steering brace, side of the tunnel.
Jdrob
"Two things are infinite: the universe and human stupidity; and I'm not sure about the universe." AE
"Two things are infinite: the universe and human stupidity; and I'm not sure about the universe." AE
- nick80lf
- Posts: 1162
- Joined: Thu Jan 14, 2010 10:45 pm
- Real Name: Nick
- Location: The snow free zone of Ohio
Re: 1983 snowfire missing at 3/4 throttle
On Larry's Snowfire it's mounted on the back side of the plate the pull start handle passes through.
Sent from my HTC One_M8 using Tapatalk
Sent from my HTC One_M8 using Tapatalk
80 Liquifire (purchased 1996 ~ Running)
80 Liquifire (purchased 2010 ~ Running....Now)
80 Liquifire (purchased 2011 ~ Not running - I officially have a problem now)
83 Snowfire (purchased 2014 father/son restoration project)
78 Spitfire ~ sold (should have been shot for this)
80 Liquifire (purchased 2010 ~ Running....Now)
80 Liquifire (purchased 2011 ~ Not running - I officially have a problem now)
83 Snowfire (purchased 2014 father/son restoration project)
78 Spitfire ~ sold (should have been shot for this)
-
- Posts: 6
- Joined: Mon Nov 10, 2014 2:18 am
- Real Name: victor lee wooldridge
- Location: underwood,iowa
Re: 1983 snowfire missing at 3/4 throttle
is it a wire or plug?
- nick80lf
- Posts: 1162
- Joined: Thu Jan 14, 2010 10:45 pm
- Real Name: Nick
- Location: The snow free zone of Ohio
Re: 1983 snowfire missing at 3/4 throttle
Here's a picture of the rev limiter. Try unplugging both plugs. The single wire goes to the switch in the throttle. The bigger plug is connected to the ignition.
[attachment=-1]uploadfromtaptalk1420506471872.jpg[/attachment]
Sent from my HTC One_M8 using Tapatalk
[attachment=-1]uploadfromtaptalk1420506471872.jpg[/attachment]
Sent from my HTC One_M8 using Tapatalk
80 Liquifire (purchased 1996 ~ Running)
80 Liquifire (purchased 2010 ~ Running....Now)
80 Liquifire (purchased 2011 ~ Not running - I officially have a problem now)
83 Snowfire (purchased 2014 father/son restoration project)
78 Spitfire ~ sold (should have been shot for this)
80 Liquifire (purchased 2010 ~ Running....Now)
80 Liquifire (purchased 2011 ~ Not running - I officially have a problem now)
83 Snowfire (purchased 2014 father/son restoration project)
78 Spitfire ~ sold (should have been shot for this)
-
- Posts: 6
- Joined: Mon Nov 10, 2014 2:18 am
- Real Name: victor lee wooldridge
- Location: underwood,iowa
Re: 1983 snowfire missing at 3/4 throttle
ok guys thanks for the help. lee