Thanks Don-
The console door is part M65104 with hardware per this diagram if the link works-
http://jdpc.deere.com/jdpc/servlet/com. ... odel=j300E
I was up in "Gods Country" as I refer to my ancestral homeland of Minnesota last week on a family vacation. Pulled the 300 and the Ski Doo out of the shed they live in and cleaned them up, unfortunately they had to be put away covered in road salt and snow from riding them when I was up in January last year, no way to clean them in the winter at dad's.
I spent an hour on the 300 with a can of spray gunk under the hood, a hosedown, and soapy water wash on the outside, then I scraped the old registration numbers off and went over the hood with Meguiar's "plastix" which I find is good for lots more than just windshields. By the way, it made my original windshiled actually see through again. Then both machines got the skis wire brushed (on the sled, gotta do what you can with limited time and resources) and hit with some "extend" rust converter, then a couple coats of Hardware Hank gloss black rust stop enamel. Probably not as good as a disassemble, sand blast, and real two part paint but much better than the rust!
Then a quick spin around the yard on the grass.
The torn seat got pulled off (naturally, there was some rot and the T nuts spun in the wood) and dropped off at Val's upholstery near Melrose MN on a recommendation from a guy on another board re doing a 300 that had his seat done there. No, won't be the OE texture but will be nice flexible snowmobile vinyl. The guy does tons of Rupp seats as well.
ME