CCW 400 Compression
-
SHOOT DEERE IT IS
- Posts: 9
- Joined: Sun Jan 22, 2012 11:06 pm
- Location: EC WI
CCW 400 Compression
I have a 71 Skiroule with a CCW 400 in it. How much compressions should it have. My tester shows over 200 per side. Sounds a little high to me.
Re: CCW 400 Compression
Maybe some one put 340 heads on it? 200 psi is a lot.
good luck, Dave
good luck, Dave
Re: CCW 400 Compression
have the cylinders been oiled? I've seen 190's before if the rings were just oiled. Once it runs, it will loosen up a bit.
DE
DE
Dustin Elder
Salem, OH
Midmounts.... Lots and lots of midmounts...
"Everyone is entitled to be stupid, but some abuse the privilege."
Salem, OH
Midmounts.... Lots and lots of midmounts...
"Everyone is entitled to be stupid, but some abuse the privilege."
Re: CCW 400 Compression
The CCW 400 runs very high compression.
I have tested them up to 215 psi without oil.
The 340/440 are not like this , only the 400.
You must use premiem fuel in this engine.
And hold on tight to the recoil ....and the handlebars.
I have tested them up to 215 psi without oil.
The 340/440 are not like this , only the 400.
You must use premiem fuel in this engine.
And hold on tight to the recoil ....and the handlebars.
Todd Schrupp
Milbank SD
Milbank SD
Re: CCW 400 Compression
Hey Guys!
I have a JD 400 w/167 psi per side. It has only 950 miles on it.
I have a JD 400 w/167 psi per side. It has only 950 miles on it.