Chain case gaskets for 340s

[MWB]

Anyone know a place to get chain case gaskets for 340s # M65697 and # M63228?

Thanks!

[cledussnow77]

I would be interested in a set or two of them to.

[400brian]

Last I knew Ed Poet had them. Deeredaze

[deere memorabilia]

I have a few M65697 gaskets. Email me at babs_4939@hotmail.com

[WinnipegStPaul9]

In all honesty you can use other material or make your own.


DA

[RLFollman]

I also have two of them available.

Randy

[deere memorabilia]

Edit-

I just needed to take a deep breath.

[RLFollman]

Hey Jessie --- no offense meant. I only threw it out there for others if there were more needed that what you have available.

Randy

[MWB]

Thanks guys. Does anyone have the M63228??

[RLFollman]

The M63228 or M63229 are used on virtually all the Deere sleds. Again, if Jessie doesn't have this, I have an M63228 available and have a few M63229 that are same except with square holes instead of round. It appears that many people have been using these interchangeably but others can chime in too if needed.

[WinnipegStPaul9]

But in all honesty the NOS cork shrinks with time and does not fit. I even tried soaking one in water a few years ago without success. Not that hard to make if you have cork material.

DA

[JDGuy]

In my experience the round holer's (M63228) are a bit larger in both OD and ID. The bolt circle diameter is a bit larger also.

[MWB]

alright, what do you guys do about gasket kit for the engine??