Here's my parts list..............

[cledussnow77]

Ok Guys Here is a list of things I'm looking for, if you have something let me know how much shipped and will send you a pm to let you know if I have it yet or not. Thanks for everyone's help. You are an awsome group of sledheads.

part# qty description

am53544- 4- piston rings
m63541- 1- seal fan side
m65395- 1- seal pto side
n132422- 2- steering shaft bushings
am52971- 2- wearrod 2 bolt
am52913- 2- drive sprocket round shaft
m65699- 2- latch
am53675- 2- hood pin covers
m65958- 1- airduct
m65983- 1
m65951- 1- isolator
am53662- 1- airduct

[JoeRainville]

Hi C-77,

Thanks for posting the P/N's. It makes it easier if you tell us what sled they fit too, and if you only want NOS or used parts.

Thanks,
-Joe

[WinnipegStPaul9]

I'm sure they are for his 340/S.

DA

[JoeRainville]

Thanks Don! A closer look at his list would have made that more obvious. Punch Bob for me:>)

Did Terry pick up my treasure yet?
-Joe

[cledussnow77]

Sorry about that Joe , I was kinda in a hurry to get the #'s posted I did forget to post that information . Thanks Don for covering that , it is for my 340/s and I would like NOS but I know some things are gonna be costly so I will take used parts in good or condition.Thanks again for any help with these parts. Ed

[400brian]

Here's a few ideas:


Ed Poet should have the rings
The crank seals are the same as any other Kioritz engine, so...anywhere.
The steering shaft bushings are still available from Deere
2 bolt carbide would have to be used or NOS
Track drivers...used or NOS
RH Hood duct...used...good luck with that
The duct baffle is just aluminum sheet, could be fabricated easily enough
The hood edge...possibly mc master carr
LH hood duct...used...good luck with that

[cledussnow77]

Thanks Brian, How do i get a hold of Ed for the rings,the track drivers and wear rods I would like NOS if anyone has these Let me know how much. Thanks Ed

[400brian]

Ed is list member: Deere Daze

He's not showing much on either of the ebay stores right now, so you'll have to ask.

[cledussnow77]

Thanks for the help Brian

[Deere Daze]

cledussnow77 Pm Sent Re:M65958

[cledussnow77]

PM sent back.

I did find a nice set of drivers , only have a few small things to find, and I think I'll wait for Don and Bob to get theirs done to get those things . Supposed to be in the 70's here on Thurs, so I will get the paint stripped and get it cleaned up .