2013 JDsleds.com Raffle Sled OFFICIAL TOPIC

[skoalmint]

Yea it hung in there literally,LOL!Brock

[Matt]

Just got off the phone with Brock, and here is the latest parts list. Thank you to everyone who has helped thus far!

One BIG item is still needed:
TRACK: Am54583 Track Sub #am53708 OR am54102 OR Kimpex

Other Parts still on the wish list:
Am54616 Throttle block
Am54619 Brake Block
M65684 Clutch spring (Black)
Am54308 Buttons and roller kit
Am54601 Shock ( Skid)
Am52312 Kill switch
Am52311 Dimmer switch
Am53863 Speedo 100mph
Am53193 Tach 10,000 rpm
M66247 Coil cover
M66351 Air duct (Behind head lt)
Am54231 Ski shocks
Am54245 Carbs (Can be purchased new if needed)
Am54616 Throttle block
Am54619 Brake Block
Am53834 Gas gauge (Original Deere Would be nice)
Tie rod ends
M66245 Spindle Bushings
Am66254 Ski bushings (still availble from Deere)
M67781 Gas tank w/ Lid #M54615
Am54672 Brake pads

Parts already donated:
SKIS: Am54678 OR AM54912 Skis in NOS or very good condition - jdsledsrgr8
M67693 Dash panel - Rainville
Deere Key - nick80lf
Am54407 Windshield - Winnipegstpaul9
Am52305 Tail light complete - nick80lf
Chaincase bearings and drive bearings - sprailfire340
Fuel pump - nick80lf
AM53754 or sub AM54238 Coils (Updated P/N) - Harleysporster
Ski isolators - Horicon Joe
Wear bars - Deerekid9
Water pump (new or rebuilt) - lwb140
Am54651 Secondary clutch (Original rusted bad) - Horicon Joe
Am54384 Chain tensioner - Rainville
M64480 Hyfax - Deerekid9
Hood foam kit - New Breed Parts
M67724 Hood cowl - Repaired by Brock
Am52930 Bar pad - Rainville
M66218 Snowflap - New Breed Parts
Decal kit - AFE Graphics (pending)
Am53799 Temp Gauge - lwb140
Am53810 Choke Cable and plungers - Harleysportster
cledussnow77 - Skid
Atomic40 - Hood

Parts donated by Brock:
Pistons
Am54224 Gasket set
Under hood decals
Am54169 CDI
Am54279 Weight kit
Am54906 Thermostat

[skoalmint]

Hey Matt,Nick donated a new Deere Key,The old switch tested and cleaned up fine.So we can cross that off.Rainville also donated a new dash panel,belt guard clip,head nuts,and suspension ,chaincase bolts.I think the dash panel is the only thing to mark off the list.Thank Brock. Ps what about the crank,Have you spoke w Jerome?

[Matt]

Which Nick is that? I have not, but I need to call him anyway. If the crank is ready to send, go ahead and ship it over to him.

[Mr. Deere]

Good was worried about that

[skoalmint]

Matt 80 liquifire nick.Thanks Brock

[Matt]

Bump, Brock still needs parts! It would be great if we could finish this sled up during the summer so we have all fall and next winter to promote it.

[WinnipegStPaul9]

Matt's right!! You can't promote ticket sales without actually having the sled done. We learned that with the last one.

[jdsledsrgr8]

Been searching around for a new track. I will keep on it.

Nick at the HOF is picking the skis up from me and will get them to Brock. They are solid skis, not NOS. They do have some rust pits. I had them powder coated, so they look pretty good.

[skoalmint]

Thanks Matt for doing that for the project. Thanks Nick for picking them up or who ever ends up with them.Its nice to see guys jump to help Thanks again Brock.

[Mr. Deere]

Matt are you guys taking cash donations? Wold like to give back for all the help you guys gave me! I don't have any parts to give for this model.

[Matt]

I will take money to pay for parts & supplies. You can Paypal to my mattspiece@gmail.com address and in the comments box, put "for JDsleds.com raffle sled'.

[JDT]

Dig deep Bob.

[Mr. Deere]

[skoalmint]

Well guys she is under primer,Should be back in black by the weekend.It has been a long process trying to make this thing look new again.I will get cledussnow to post some pics as soon as we get her painted.Thanks guys Brock