I finally finished up a project that took most of the summer to finish. Bought it this spring needing at least a cylinder and piston on the Mag side. (if only it was that easy) I got lucky and found a good rebuilt long block and installed all my electronics carbs and exhaust. got the eng in and tried to fill the A/F and it ended up all the ground. the bolt for the susp had come out and poked a hole in the radiator. (studded track) eng got REALLY Hot the Oil Inj lines were melted. Got he susp fixed and replaced the radiator. and now I have a pretty nice sled. had it out for spin today. Runs nicely starts on the 1st pull everytime.
After my ride I got to work on my long postponed 340/s got the pan straightened and steering back in place. Progress!
My neighbor and riding buddy has one just like that. Been a good sled. Too bad he still doesn't have the rear idler bearing replaced so we can go riding!!!!!
eng got REALLY Hot the Oil Inj lines were melted. Got he susp fixed and replaced the radiator. and now I have a pretty nice sled. had it out for spin today. Runs nicely starts on the 1st pull everytime. 
