2013 JDsleds.com Raffle Sled OFFICIAL TOPIC

Post by **Matt** » Wed Mar 20, 2013 7:42 am

Brock, I spoke to AFE last year and they were on-board, I'll touch base with him again. I can probably order new tie-rod ends through New Breed but I'm not sure about the links? I'll check.

Post by **Matt** » Wed Mar 20, 2013 7:14 pm

Confirmed that AFE Graphics/JDsleddecals is on board to donate the decal set!

skoalmint · Post by **skoalmint** » Wed Mar 20, 2013 8:27 pm

Good Deal, Thank you AFE Graphics ,You guys have amazing products .I think they are the same as the tie rods Matt ? Thanks Brock

skoalmint · Post by **skoalmint** » Sat Mar 23, 2013 11:34 pm

Hey guys, Thank You mailman for donating the bushings, one problem solved.We still need spindles .Thanks guys Brock

Post by **WinnipegStPaul9** » Sun Mar 24, 2013 10:15 am

Brock, my CC inventory says I have two used ones but no new ones, sorry.

DA

skoalmint · Post by **skoalmint** » Sun Mar 24, 2013 11:45 am

Hey DA ,Do they look like they are egg shaped where the pivot bushing slides in ? The ones off of the sled are egg shaped. Brock

Post by **WinnipegStPaul9** » Sun Mar 24, 2013 12:09 pm

I'll check.

DA

Post by **WinnipegStPaul9** » Sun Mar 24, 2013 1:27 pm

Brock, they're just not worthy of this project. Sorry.

DA

skoalmint · Post by **skoalmint** » Sun Mar 24, 2013 9:21 pm

Thanks for looking DA.Brock

cledussnow77 · Post by **cledussnow77** » Mon Apr 08, 2013 7:39 pm

Ok guys, I got the updated pictures from Brock. Looks like he's been a$$hole deep to a 10 foot indian in work down there with this sled and a new building. So far it looks really good. This thing is just about ready to start going back together and we need to get the rest of the parts ASAP so we can set up a build day and finish this thing up so we can get started selling tickets.