Work on The Twins begins

sledhead16 · Post by **sledhead16** » Thu Mar 05, 2015 9:13 am

My buddy has a lil parts washer that works great with Pin-Sol! She was covered in grease topped with barn dust lol. Yeah I have TOO many projects sitting around right now lol. Motor got all new NOS top end kit, New orings and seals on crank, new pto bearing and trued. New NOS gearcase gasket and waterpump gasket. New Rings, basically standard overhaul

sledhead16 · Post by **sledhead16** » Thu Mar 05, 2015 9:13 am

oh and new mikuni carb flanges, thanks to freaky fast shipping from newbreedparts!

sledhead16 · Post by **sledhead16** » Thu Apr 23, 2015 9:21 pm

Kayla helping me pull out the shaft....

Jd sled rider · Post by **Jd sled rider** » Thu Apr 23, 2015 10:15 pm

Hopefully the rest of the night goes well!!!!!!!! Later Lincoln

JDT · Post by **JDT** » Fri Apr 24, 2015 8:35 am

sledhead16 · Post by **sledhead16** » Fri Apr 24, 2015 10:35 am

Just realized I didn't tag a picture......now that's funny

JDT · Post by **JDT** » Sat Apr 25, 2015 8:25 am

Buffalo Board?? Have not seen that in a few years.

sledhead16 · Post by **sledhead16** » Sun Apr 26, 2015 8:38 pm

Todd, 78 rambler lol

JDT · Post by **JDT** » Mon Apr 27, 2015 7:42 am

My folks did a Capp Home in 68 and there was a truckload of that stuff used on it.

sledhead16 · Post by **sledhead16** » Tue Apr 28, 2015 8:53 am

lol it's ok stuff

Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins

Re: Work on The Twins begins