The other day I was reading through the clutch alignment procedure for the Snowfires. I know the manual tells you to use the JDG-369 tool, but I noticed it mentions the center distance should be 274mm. Is this tool really noting more than a fancy tape measure that takes into account shaft diameters to automatically find the center of each shaft?
If that's the case I'm thinking a person could measure the outside edge of the clutch shaft and drive shaft (maybe with a 12" caliper) and subtract the appropriate amount from the measurement to account for finding the shaft centers.
JDG-369 clutch tool questions
-
nick80lf
- Posts: 1225
- Joined: Thu Jan 14, 2010 10:45 pm
- Real Name: Nick
- Location: The snow free zone of Ohio
JDG-369 clutch tool questions
80 Liquifire (purchased 1996 ~ Running)
80 Liquifire (purchased 2010 ~ Running....Now)
80 Liquifire (purchased 2011 ~ Not running - I officially have a problem now)
83 Snowfire (purchased 2014 father/son restoration project)
78 Spitfire ~ sold (should have been shot for this)
80 Liquifire (purchased 2010 ~ Running....Now)
80 Liquifire (purchased 2011 ~ Not running - I officially have a problem now)
83 Snowfire (purchased 2014 father/son restoration project)
78 Spitfire ~ sold (should have been shot for this)