Another Day at the Office

Danzig · Post by **Danzig** » Sat May 19, 2007 9:50 pm

Not good.

400brian · Post by **400brian** » Sun May 20, 2007 1:03 am

It certainly doesn't look good, but what exactly are we looking at, and what happened?

Rodimus Prime · Post by **Rodimus Prime** » Mon May 21, 2007 1:03 am

what are you forging?

Danzig · Post by **Danzig** » Thu May 24, 2007 8:16 pm

This is a picture of a robot placing parts into a heat treat. It had a malfunction on the left side. The parts are drive line components for Dodge trucks. This is the same machine I was going to heat treat a homemade clutch puller for last year, which never happened. The grease deposits are normal, this is actually quench oil residue which is used in heat treat processes.

Rodimus Prime · Post by **Rodimus Prime** » Fri May 25, 2007 1:08 am

heat treating was a second guess.

okay i give which drive line component. they dont look like a pinion nor a tranny part that i know of .. dont even look like the front driven axle of a 4x4..

of course i dont know the dodge (ugly) trucks 95 & up that well either my best guess is that they may be the start of the OD shaft for the shitty new trannys.