part number ?

Trucker · Post by **Trucker** » Fri Sep 14, 2007 6:08 pm

what does part number AM55588 fit?

Mr. Deere · Post by **Mr. Deere** » Fri Sep 14, 2007 7:51 pm

I dont know and i cant find it on the Jd parts site under any sled. What is it. BOB

JoeRainville · Post by **JoeRainville** » Fri Sep 14, 2007 10:54 pm

Hi Trucker,

Can you give me a better idea what the part is, a decription or might be from? I check my Deere CD for the sled manuals and I couldn't find it either. It might be a superceeded number or something.

-Rainville

Trucker · Post by **Trucker** » Fri Sep 14, 2007 11:06 pm

Its a gasket set that Dk has on one of there Lots and i was curious on what it would fit
i cant give you anymore info than they have on the list
AM55588 QTY 100 GASKET SET

JOHN DEERE: SPECIFIC FITMENT UNKNOWN
So if you guys don't know its a real mystery

deeredr · Post by **deeredr** » Sat Sep 15, 2007 2:13 am

That's all I show too, a gasket set. We must have sold one sometime or another in the past. Last list price (remember, OLD prices!) was $35.39

I bet Joe's right, it the # changed then it will be a lot harder to reference what it fit.

Greg

400Chris · Post by **400Chris** » Sat Sep 15, 2007 10:09 am

AM55588 = 1980-1984 Liquifire top end gasket set.

Chris

cyclone crazy · Post by **cyclone crazy** » Sat Sep 15, 2007 10:15 am

Trucker wrote: Its a gasket set that Dk has on one of there Lots and i was curious on what it would fit
i cant give you anymore info than they have on the list
AM55588 QTY 100 GASKET SET

JOHN DEERE: SPECIFIC FITMENT UNKNOWN
So if you guys don't know its a real mystery

Check under the classified section. I'm blowing out a bunch of these sets.

cyclone crazy · Post by **cyclone crazy** » Sat Sep 15, 2007 10:17 am

Trucker-

do you have jetting specs for an Invader with twin 38's?

Trucker · Post by **Trucker** » Sat Sep 15, 2007 10:24 am

cyclone crazy wrote: Trucker-

do you have jetting specs for an Invader with twin 38's?

I slightly ported a invader last winter and with 38's and Aaen pipes i found 340 mains and 35 pilots was just about right on that sled. I dont remember what needle or slide i had in there and i sold the sled so i cant help you on that.
I had 350 mains and it ran at just under 1100 on the egt but was a bit on the rich side yet so i told the guy that bought it to put 340's in.

cyclone crazy · Post by **cyclone crazy** » Sat Sep 15, 2007 10:43 am

Thank you for the info. This should get me close for a starting point.

Mr. Deere · Post by **Mr. Deere** » Sat Sep 15, 2007 7:46 pm

Chris how did you find it. BOB

400Chris · Post by **400Chris** » Sat Sep 15, 2007 11:24 pm

Bob- Believe it or not, I actually had two sets on my desk with the part number on it. Right place at the right time for once.

Chris

Mr. Deere · Post by **Mr. Deere** » Sun Sep 16, 2007 5:10 pm

Nice. BOB