KEC 340/5 PTO crank seal

jd ike · Post by **jd ike** » Fri Jan 18, 2008 12:09 am

I had my local dealer order one, but it was narrower than the stock seal. Would it be alright to use?

JDT · Post by **JDT** » Fri Jan 18, 2008 12:22 am

Shy away from NOS or new old stock seals because they are "old". Can be dried out.
Use fresh (newer) seals.

Seals come in serveal thicknesses for the same id/od.
If it called for a 10mm thick seal and you have an 8mm it will work.

Todd

jd ike · Post by **jd ike** » Fri Jan 18, 2008 12:33 am

Winderosa calls out a 1333 for both sides but this doesn't work, too small of an ID. I purchased the complete gasket kit and it came w/ two of these. It states a 1302 but it's thinner. I will have to measure it tomorrow and if it's within 2mm I'll take your word and installl it.

Thanks