Wow! Thanks for sharing this story........so cool

I think I have a steering linkage....but whats a TPR panel?

just as an update for everyone (and incase anyone uses this for reference later) my problem was the stator.... it was my own fault earlier in the year I tried to put the guts off a recoil from a yamaha enticer (I was frustrated with the JD one) it does not fit properly (no clearance) but it gives th...

So....out on the lake running the liquifire (trying to chase a bad ground as the lights were flickering) and I go WOT for about 600 feet and it was hesitating a bit around 6-7k then it went to redline around 8k screamed along and than it was like I hit the kill switch and she rolled to a stop withou...

80spitfire wrote:Here's my Dator at Waconia this year

SAWEEET!!!

Has anyone else had problems with setting up their recoil guts? Like the 3 pawl springs and the 2 springs around the post,with the plate...ugh I had rebuilt mine last year and it exploded the other day? I'm pretty sure I put it together properly? It's a frigging cookoo clock in there! Are there any ...

JDT wrote:Picture looks like a lean condition to me.

Yeah it is a little...hmmm?

Ok...

I put a new coil on it and just got back from a 15 mile run and it ran well the whole time, so hopefully that solves it.

I really appreciate all of your input and help!

Jon

The clutch issue...yup maybe...

But if I got a backfire when I was holding it to the bar doesn't that mean too much fuel?

temp gauge was at the bottom (and it works) so I don't think it was too hot?

Here is pic of the plugs

toasty brown...both of them

like a toasted marshmallow

Ok....I can't find a forum that describes all my circumstances 1980 Liquifire when its colder (like first 10 - 15 minutes) of running it runs fine in the top end it pulls @ 8200 no prob when the sled warms up (like 10 miles into ride) it wont rev when I give WOT it will got to a little over 7000 and...

Could also be jackshaft bearings that was one of my problems when my liquifire was acting similar......
My 2 cents.....

I have spare heads if you need one its ok I have another set...thanks for the offer Have you been to Byers Equipment yet? They were a huge Deere dealer and had a lot of left over stuff. Yes I have been there a few times, there inventory is depleted now.......but I have used them as a resource and t...

asking 650

in Orillia, Ontario


http://barrie.kijiji.ca/c-cars-vehicles ... Z446787821