Ok guys I'm back. I took a break for a bit(no snow anyway).so.i bought and installed a new cdi and separate coil for a. 83 trailfire 340. I also had and installed a known good stator and lighting coil from same sled.. low and behold sled started on 2nd pull( with choke full on and gas in carb). IT I...

Sorry guys.... been awhile I was and still am super frustrated. No snow in central Iowa anyway. But what I'm worried about is the upcoming high humidity coming here on summer and my motor is not broken in. Also all the flooding in the engine might have just wasted the $1000 plus I've put in the moto...

I will check and see about another inlet needle,and I did buy new floats just to be sure and yes they are in correct. Pins down and to the inside. Thanks for responding. Very appreciated. I have a motion pro leak down tester that possibly I can hook up and put some pressure on needle and see what's ...

Maybe someone can please help me here. My original VM30 Mikuni pours gas out the needle jet in the middle when fuel shutoff is turned on. Here is what I have done to sled. Motor has been completly rebuilt all new bearings and o-rings on crankshaft thorough northern C, new nickasel'd cylinders, new p...

So can I run my cast rings in my nickasel cylinders
I read from a mellenium article years ago that you can run any ring with nickasel cylinders

Iam interested in 2 tracks also.if I'm not to late

Rodimus Prime wrote: ↑Sat Sep 08, 2007 11:21 pm piston number 09-689 Or if you really really want custom rings made i can get some.

Can you still get rings?

Did you get chrome rings? If so where?
And the arrow on these S.P.I pistons the arrow is pointing the right way. The rings don't pass over any ports. But they came with rings for a chrome cylinder. Soni believe there Cast iron rings, witch is not compatible with nickasel cylinders

I recently had my 340 cylinders nickasel'd and I cannot find a piston kit with chrome rings. Anyone have any ideas

Ok guys....I have an issue. Iam hoping all you informed guys or gals can help. I bought a set of Kawasaki Free Air cylinders awhile back with pistons,rings,circlips from eBay that were supposedly tested at Kawasaki factory.( You may have seen them,still on there). They are 60mm chrome bore. Chrome i...

Ok thanks matt

Does anyone know the part number for the bottom rod bearings,crankshaft bearings,and bearing orings for a 1983 JD Snowfire. It has the Kawasaki TB340A-C202 motor in it. Also what about the center seal? Do I just replace the o rings around it? Any help would be great. I'm planning on sending crank to...

Iam planning on having melenium technologies rechrome or nickasil both my cylinders on a 83 JD Snowfire. It only has 110 compression in both cylinders. My question is that I heard JD site members get a 15percent discount. How do I apply this when talking with melenium tech or while paying for there ...

Iam interested in a track as well please mesg me at 641-840-1087. Or email jasonhanna18@gmail.com. thank you

1983 John Deere snowfire J34XM SERIAL#222059M. DATE 8-82
sled was complete except blown left cylinder. Seat ripped up by coons.
Found in barn in newton,iowa. Where I live. Paid $200 with extra exhaust and vintage helmet.