Proper Carb for the '77 300?

Technical topics related to machines powered by Kioritz/CCW & Kohler motors.
Post Reply
thekingofclubs
Posts: 15
Joined: Thu Nov 27, 2014 11:26 am
Real Name: Tony
Location: Saskatchewan

Proper Carb for the '77 300?

Post by thekingofclubs »

Hi folks,

I'm so close to getting my 300 ready to ride. It was running ok but wouldn't idle great so I decided to check out the carb. I had just went through this carb less than 2 years ago and it looked pretty good but i still replaced all the gaskets etc. It sat for a couple years and there must have been some water in the system because when I got the stack open it was full of rust above the fuel pump. It didn't look anything like this the first time I had it apart. I'm suspecting a poor quality (rusted) hose clamp on the in-tank fuel fitting to be the source. No surprise, all 3 screws on the circuit plate snapped clean off when I tried to remove them. Looks like I'll be tracking down a whole new carb body.

Does anyone know which carb is the right one for a 1977 300? This one says WDB-31. The info I have all points to WDA? Not sure if it makes a different but just wanted to check before i begin searching for one.

Thanks!
Attachments
Rusted Carb.JPG
User avatar
jep_800
Posts: 445
Joined: Wed Dec 31, 2014 1:33 pm
Real Name: Jason
Location: Grand Forks, ND

Re: Proper Carb for the '77 300?

Post by jep_800 »

Tony, I have the Parts manual open and it does say WDB-31 for a Model 300 sled.

jep_800
1975 John Deere 800
1975 JDX8 (VC Finisher 2019)
1976 440 Cyclone (VC Finisher 2022)
1974 El Tigre 440 (Sold)
1996 Arcitc Cat 440Z
thekingofclubs
Posts: 15
Joined: Thu Nov 27, 2014 11:26 am
Real Name: Tony
Location: Saskatchewan

Re: Proper Carb for the '77 300?

Post by thekingofclubs »

Thanks Jason, any idea what the difference between the two is?
Post Reply