Some triva for what it is worth:
In attempt to do a 100% NOS "perfect" 80 Liquifire restoration, I needed some vinyl hood edge molding in which I could not find NOS. After several hours of web search and finding expensive 400 foot rolls that looked like the right stuff, I finally found a source that is a perfect match and they only charge $1/foot +regular rate UPS ground, no shipping holdups with big handling fees and etc. One sled needs a little less than 4 feet. Should you be interested the source is as follows: (yep, Flordia, heavy snow-sled country!!!)
Danno Enterprises
www.dannoenterprises.com
Port St. John, FL 32927
321-452-8101
The order no. is a follows:
part # 0708, quick edge - black 1/8" GR (7500 0708)
Special order - non stock item.
Hood edge molding
Forum rules
New posts in this forum are limited to approved members. Any one can reply to the existing topics. PM "Matt" for approval to post new topics in this forum.
New posts in this forum are limited to approved members. Any one can reply to the existing topics. PM "Matt" for approval to post new topics in this forum.
Hood edge molding
Industrial supply houses also carry it. It is called safety trim or push on trim edge. I got mine from: http://www.mcmaster.com/ ~ page:3537
Also seen it being sold at: Tampa Rubber & Gasket Co., Inc.
http://www.tamparubber.com/index.htm
bob
Also seen it being sold at: Tampa Rubber & Gasket Co., Inc.
http://www.tamparubber.com/index.htm
bob
When in doubt, I'll whip it out. I got me a rock 'n 'roll band. It's a free for all.....The Nuge
Make it three yards m*****f-er and you've got yourself an automobile race...James Taylor
Make it three yards m*****f-er and you've got yourself an automobile race...James Taylor