Troy, call me on Weds, I'll be home then & probably can help you..

Grumpy

I seems that now days a lot of the racers are going to the Skidoo Electronics, I'm not sure which Sled/Engine there taking these parts from?? Stator, Flywheel, Electronics Box/CDI but then they install them on there race sleds.. ( Flywheels have to be modified to fit there certain engine make ) Just...

I think you guys worry too much about the front leafs, granted we did snap some bolts that held the Multi-Leaf springs togather on the Dators but once Deere came out with the Mono-Leafs we didn't have anymore problems, It probably helped that we had the front suspension spring cranked right up tight...

rob, I believe the part numbers are the same. This past winter Chris & I fabricated a couple of Dator air tubes from scratch, I think that they turned out to be as good looking as the Chinese ones I had repoped... If someone can send me one from a trailfire or sportfire I'll try them out when I ...

jdrob, that could be a possibility, but I think that the airbox screens would also be a good repop???

Grumpy

Jon, although I agree with the choice for the reliability, I have my doubts about the speed of the Cyclone for which you professional ditch runners are accustomed to, & unlike the 340/S engine I don't think that the gearing can be raised to gain speed without sacraficing the power of the Cyclone...

Send the crank out to get the bearings cked &/or replaed. on reassembling the motor make sure you follow the specs in the service manual precissly ( sorry don't have spell check over here )especialy when installing the PTO side cover, just becase you took out a certain amount of shimes doesn't m...

Tasky: Want to trade for something? Would require you to deliver to Palisade after Christmas...

Grumpy

Are these other hoses something we should be thinking about repopping also?? along with the older Liquifire hoses & Dators & Sprintfires also??

Grumpy

I believe I have one ( M68313 ) that will be on it's way in a couple of days..
Thanks
Grumpy

Huh, I looked in there & didn't find that info, thanks for spotting it for me..
I was afraid of that, thats still over 1/2" shorter than what I need.
The project I'm working on has a 12.5" C/C distance..
Thanks for the info... I'll have to look at other brands

Grumpy

Harley is the offset so different that the older one won't fit the new sleds? is the newer support made from Tubing or Wire/Rod? jdrob,Can anyone of you guys DHL or Fedex me a NOS or very good & straight M68313 support? Shipping won't be cheap but IF you guy's want the newer one repopped now is ...

What is the diference between the M66848 & M68313 Snow Flap Supports? Is It that the M66848 is made from tube & the M68313 is made of rod? Will the M66848 work for a repopped replacement for the M68313? Would it make any difference to you guys IF the M66848 Snow Flap Supports were 1 MM large...

Wade could you get me the C/C distance between the two clutches on your 80 CC Liquifire? I don't seem to have one available where I'm at.... I'm needing a 12.5" C/C Thanks Harley I'll check on that when I get back & can get my mesurements correct. Wade, the 83 FT Manual doesn't give a mesur...

Anyone know what the C/C distance is on the crank to jack shaft on a newer Liquifire? Is there a differance on the C/C distance on the Liquifires with the TR800 clutches? Are the belts longer on the sleds with the TR800's? What would be the easiest way to figure out a belt length on a sled with a 12...