I looked at that tunnel when it was there it is gone now ( don't know if it was bought or scraped ) the back 12inchs was replaced and the front sub frame had been lighten(was drilled with holes)

anybody in mid mich that need track and booges wheel for I think a 300?.The frist part if the tag was 3000or 300C I was at the junkyard in Mt. Pleasant today and seen a sled look like new ( but had a hole in the side if the tunnel)the track was good and most if the wheel were very nice. The sled had...

The 76-77 main is only 150or155. but that is a diffrent carb that might be right.

Just give them the part number for the wiseco piston and they can use that and make the right one from that 2012

Got the one off that was fun!! warming it up with a hairdryer helped( no heat in the shop maybe someday) now I need a new dimmer swicth Rich would you have one to sell Thanks Steve

Thank rich I will see if I can get them off

The dimmer switch is messed up on my sprintfire I want to keep the JD hand grips so can I get them off without cutting. If I have to cut them to get them off doe's anyone know where I can get one to replace it. PS. don't buy cheap throttle cables got two lap on the 340/s and it broke #423

If you can find a 340 yamaha exciter piston it will work in the 340/s .the pin to deck is the same and the pin is the same.but you will have to cut some of the skirt off. The yamaha piston is a single ring piston

I used the disk from the cat and the center from the 340/s. The cat disk is the same as the JD but the shaft size was to small. On the cat the disk is bolted on so I just drilled the rivet out of the 340 and used that center. Because my disk was very pited and rusty. I think it was from a mid 70's c...

Iused the disc from And old cat,but you have to drill the rivet out and use the bolt , the jackshafts are different

FIII I will try to find some hose I know where you used it on the RV. if that don't work out I think the RTV would be easy to do thanks for the help Steve

the exhaust mount on my sled(340/S) that is in the middle of the pipe is wore bad so I was thinking of putting a piece of rubber under it. What do you think ? the pipe is not wore but there is a big weld right there and it has wore a small hole in the mount

Thanks I just discovered that my box is on the wrong side all this time

I'm puttung this sled together for a 13year old to race.Don't know if I can run twin pipes.One of the kids in the class has a GPX with a 292 single. My son has a 250 enticer and I don't know of anybody that makes gears for this thing.I have lots of SRX part.I was not sure if the enticer and exciter ...

I would like to find the pipe for one because it goes around the right side of the motor, I think the 340 EX motor is the same as the 340enticer but there pipe goes on the left side. All I need is the motor because I'm using and SRX frame